Heat trap

Microcirculation on the left: Heated water is rising into the pipe on top of the hot water tank, cooling off on the sides of the pipe and thence circulating back into the tank.
Right: Circulation of hot water is inhibited by the loop in the pipe.

Heat traps are valves or loops of pipe on the cold water inlet and hot water outlet of water heaters. The heat traps allow cold water to flow into the water heater tank, but prevent unwanted convection and heated water to flow out of the tank. Newer water heaters have built-in heat traps.

About

Many water-heating pieces of equipment have integral heat traps installed from the factory. For water-heating equipment that does not already have factory installed heat traps, they must be purchased then installed in the inlet and outlet connections.

Heat traps are very simple and inexpensive. They are an effective way to prevent cooling of hot water in water heaters by thermosyphoning the hot water to a higher elevated portion of the piping system. Thermosyphoning is based on natural convection. Hot water rises and is then displaced by cold water beneath it. The heat trap stops this process, thus keeping the hot water inside the insulated storage tank.

See also

• Plumbing – Systems for conveying fluids
• Thermosiphon – Method of heat exchange in which convection drives pumpless circulation
• Thermal barrier – Minimization of heat transferPages displaying short descriptions of redirect targets
• Thermal pad – pad on a printed circuit board connected to surrounding copper with a thermal connectionPages displaying wikidata descriptions as a fallback

Literature

• Have we forgotten to make heat traps? Archived 2018-08-07 at the Wayback Machine, Esbe AB, May 2012