Classification of distal radius fractures

From WikiProjectMed
Jump to navigation Jump to search
Fracture with a dorsal tilt. Dorsal is left, and volar is right in the image.

There are a number of ways to classify distal radius fractures. Classifications systems are devised to describe patterns of injury which will behave in predictable ways, to distinguish between conditions which have different outcomes or which need different treatments. Most wrist fracture systems have failed to accomplish any of these goals and there is no consensus about the most useful one.

At one extreme, a stable undisplaced extra-articular fracture has an excellent prognosis. On the other hand, an unstable, displaced intra-articular fracture is difficult to treat and has a poor prognosis without operative intervention.[citation needed]

Eponyms such as Colles', Smith's, and Barton's fractures are discouraged.[by whom?]

Anatomy

An anatomic description of the fracture is the easiest way to describe the fracture, determine treatment, and assess stability.[according to whom?]

  • Articular incongruity
  • Volar or dorsal tilt
  • Radial inclination
  • Radial length and ulnar variance
  • Comminution of the fracture (the amount of crumbling at the fracture site)
  • Open (compound fracture) vs. closed injury
  • Associated ulnar styloid fracture
  • Associated soft tissue injuries

Articular incongruity

The articular joint's surface must be smooth for it to function properly. Irregularity may result in radiocarpal arthritis, pain, and stiffness. More than 1 mm of incongruity places the patient at a high risk for post-traumatic arthritis. Significant articular incongruity typically occurs in young patients after high energy injuries. If the surface is very irregular and cannot be reconstructed, then the only option may be a fusion of the joint.

Volar vs dorsal tilt

A dorsal tilt of a distal radius fracture is shown in red in image at right. The angulation goes between:[1]

  1. A line drawn between the distal ends of the articular surface of the radius on a lateral X-ray.
  2. A line that is perpendicular to the diaphysis of the radius.

Sometimes, the diaphysis of the radius is hard to distinguish from the ulna, and a line between them (turquoise line in image) may be used instead.[2]

Fracture with a decreased radial inclination (about 15°).

The angle normally has volar tilt of 11° to 12°. The most common fracture pattern usually demonstrates malalignment of this angle and collapse in a dorsal direction. A dorsal tilt of 0° (11° - 12° deviation from normal anatomic position) causes a substantial risk of developing pain and impaired function.[3] After closed reduction, a residual dorsal tilt of a maximum of 5° (16° - 17° deviation) is regarded as the maximal residual angle for a satisfactory result.[3]

Radial inclination

The radial inclination of a distal radius fracture is shown in red in image at right. The angle is measured between:[4][5]

  1. A line drawn between the distal ends of the articular surface of the radius on an AP view of the wrist.
  2. A line that is perpendicular to the diaphysis of the radius.

Radial inclination is normally 21-25°.[6]

Radial length and ulnar variance

Radial length is an important consideration in distal radius fractures. Radial length should be between 9-12mm.[7] Distal radius fractures typically result in loss of length as the radius collapses from the loading force of the injury. With increasing relative lengthening of the uninjured ulna (positive ulnar variance), ulnar impaction syndrome may occur. Ulnar impaction syndrome is a painful condition of excessive contact and wear between the ulna and the carpus with an associated is a degenerative tear of the TFCC.

Positive, neutral, and negative ulnar variance. Relationship between radial length and ulnar variance. Radial length is the measure from distal ulna to radial styloid process. When ulnar variance is neutral radial length should be between 9-12mm.[7]

Melone classification

The system that comes closest to directing treatment has been devised by Melone. This system breaks distal radius fractures down into 4 components: radial styloid, dorsal medial fragment, volar medial fragment, and radial shaft. The two medial fragments (which together create the lunate fossa) are grouped together as the medial complex.[8]

Type Description Note
I No displacement of medial complex
  • No comminution.
 Fracture is stable after closed reduction
II Unstable depression fracture of lunate fossa ("die-punch")
  • Moderate/severe medial complex displacement.
  • Comminution of dorsal and volar cortices.
  • IIA - Irreducible, closed fracture.
  • IIB - Irreducible, closed due to impaction
III Type II fracture plus a 'spike' of the radius volarly May impinge on median nerve
IV Split fracture
  • Severe comminution
  • Rotation of fragments.
 Unstable
V Explosion injuries
  • Severe displacement/comminution
 Often associated with diaphyseal comminution

Frykman classification

Though the Frykman classification system has traditionally been used, there is little value in its use because it does not help direct treatment. This system focuses on articular and ulnar involvement. The classification is as follows:[9]

Radius Fracture Ulna Fracture
Absent Present
Extra-articular I II
Intra-articular involving radiocarpal joint III IV
Intra-articular involving DRUJ (distal radio-ulnar joint) V VI
Intra-articular involving both radiocarpal & DRUJ VII VIII

Universal classification

The Universal classification system is descriptive but also does not direct treatment. Universal codes are:[10]

Type Location Displacement Sub-type
I Extra-articular Undisplaced
II Extra-articular Displaced A: Reducible, stable 

B: Reducible, unstable

C: Irreducible 

III Intra-articular Undisplaced
IV Intra-articular Displaced A: Reducible, stable 

B: Reducible, unstable 

C: Irreducible 

D: Complex 

AO/OTA classification

Widely used system that includes 27 subgroups. Three main groups based on fracture joint involvement (A - extra-articular, B - partial articular, C - complete articular). Classification further defined based on level of comminution and direction of displacement. A qualification (Q) modifier can be added to classify associated ulnar injury.[8]

Fernandez classification

Simplified system developed in response to AO classification, intended to be based on injury mechanism with more treatment-oriented classifications (treatment suggestions not meant to be used as rigid guidelines but can be used to help decision making on a case-by-case basis)[11]

Type Description Stability Number of Fragments Associated Lesions (see below) Recommended Treatment
I Bending fracture - metaphysis Stable or unstable 2 main fragments with variable metaphyseal comminution Uncommon Stable -> conservative

Unstable -> percutaneous pinning or external fixation

II Shearing fracture - articular surface Unstable 2, 3, comminuted Less uncommon Open reduction with screw-plate fixation
III Compression fracture - articular surface Stable or unstable 2, 3, 4, comminuted Common
  • Closed
  • Limited arthroscopic release
  • Extensile open reduction
  • Percutaneous pins plus external and internal fixation
  • Bone graft
IV Avulsion fracture, radiocarpal fracture, dislocation Unstable 2 (radial/ulnar styloids), 3, comminuted Frequent

(especially ligamentous injury)

Closed or open reduction with pin/screw fixation or tension wiring
V Combined fracture (high-energy injury) - Often intra-articular and open Unstable Comminuted Always present Combined treatment

Note: Associated Lesions include carpal ligament injury, nerve injury, tendon damage, and compartment syndrome

References

  1. ^ Piva Neto, Antonio; Lhamby, Fabio Colla (2011). "Fixação das fraturas da extremidade distal do rádio pela técnica de kapandji modificada: avaliação dos resultados radiológicos". Revista Brasileira de Ortopedia. 46 (4): 368–373. doi:10.1590/S0102-36162011000400004. ISSN 0102-3616.
  2. ^ Paresh K Desai. "Colles fracture". Radiopedia. Retrieved 2016-12-18.
  3. ^ a b Page 347 in: William P. Cooney (2011). The Wrist: Diagnosis and Operative Treatment. Lippincott Williams & Wilkins. ISBN 9781451148268.
  4. ^ Jack A Porrino Jr. (2015-10-20). "Distal Radial Fracture Imaging". Medscape. Retrieved 2016-12-18.
  5. ^ Pankaj Kumar Mishra; Manoj Nagar; Suresh Chandra Gaur; Anuj Gupta (2016). "Morphometry of distal end radius in the Indian population: A radiological study". Indian Journal of Orthopaedics. 50 (6): 610–615. doi:10.4103/0019-5413.193482. PMC 5122255. PMID 27904215.
  6. ^ Page 783 in: Joshua Broder (2011). Diagnostic Imaging for the Emergency Physician. Elsevier Health Sciences. ISBN 9781437735871.
  7. ^ a b Adam, Greenspan (2015). Orthopedic imaging : a practical approach. Beltran, Javier (Professor of radiology) (Sixth ed.). Philadelphia. ISBN 9781451191301. OCLC 876669045.{{cite book}}: CS1 maint: location missing publisher (link)
  8. ^ a b Court-Brown, Charles; Heckman, James D.; McKee, Michael; McQueen, Margaret M.; Ricci, William; III, Paul Tornetta (2014). Rockwood and Green's Fractures in Adults. Lippincott Williams & Wilkins. ISBN 9781469884820.
  9. ^ Wheeless Online
  10. ^ Brown, David E.; Neumann, Randall D. (2004). Orthopedic Secrets. Elsevier Health Sciences. p. 182. ISBN 9781560535416.
  11. ^ "AO Surgery Reference". www2.aofoundation.org. Retrieved 2017-10-31.
Retrieved from "https://mdwiki.org/wiki/Classification_of_distal_radius_fractures"